Header Only - DO NOT REMOVE - Extreme Networks

Is possible to assign a tag to eth1 interface of NAC virtual applaince?


Userlevel 3
Hi, is possible to configure the secondary interface eth1 of the virtual NAC gateway as a tagged interface?

Thanks

5 replies

Userlevel 7
Hi Antonio,
I believe you'll be better off configuring this on the vSwitch (assuming VMware) so that you can ensure the traffic leaves the host tagged.
Userlevel 3
You can create another port group on the same virtual switch on a specific vlan (i.e. 10) and the NAC traffic on that port group that will leave the same physical port on vlan 10. everything on VMNET10 will also see that traffic tagged as vlan 10.


Userlevel 3
Matthew Hum wrote:

You can create another port group on the same virtual switch on a specific vlan (i.e. 10) and the NAC traffic on that port group that will leave the same physical port on vlan 10. everything on VMNET10 will also see that traffic tagged as vlan 10.


oops. i just noticed that my first screenshot had promiscuous mode set to reject. this should be accept.
Userlevel 3
Thanks Matthew for your suggest. I'll try to do this change and see how it works..

Reply