Hello everyone
Currently in charge of managing an old network.
My equipment is Switch Extreme Summit X250e.
Version OS :
Primary ver: 12.5.4.5
Secondary ver: 12.5.4.5
patch1-20
Config Selected: primary.cfg
Config Booted: primary.cfg
primary.cfg Created by ExtremeXOS version 12.5.4.5
I want to download new configurations(.xsf) to swich with TFTP
My PC is connected via the console port (front panel) with teraterm + MTMG network jack (back panel).
The network conf of my PC is as follows:
IPv4. . . . . . . . . . . . . . . .: 10.10.10.11 (preferred)
Subnet Mask. . . . . . . . 255.255.255.0
Default Gateway. . . . . . . . .:
The Switch Network Conf is as follows:
---------------------------------------------------------------------------------------
ADMIN 25 172.25.0.207 /16 ----------------- ANY 0 /2 VR-Default
DATA 10 --------------------------------------------- ANY 0 /26 VR-Default
Default 1 --------------------------------------------- ANY 0 /0 VR-Default
Mgmt 4095 10.10.10.10 /24 ----------------- ANY 1 /1 VR-Mgmt
VOIP 100 ------------------------------------------ ANY 0 /26 VR-Default
I apply the procedures found on this site but
Ping pc => Switch = OK
Ping Switch => PC = Nok
Switch summit # ping 10.10.10.11
Ping(ICMP) 10.10.10.11: 4 packets, 8 data bytes, interval 1 second(s).
Packet transmit error; Destination unreachable
they are the minimum configuration for swsitch and PC to communicate??
Is there a routing table to configure? if so how to configure it with the mgmt port?
I’ve been looking for solutions, but nothing works.
thank you in advance for your answers