Skip to main content (Press Enter).
Skip auxiliary navigation (Press Enter).
Terms and Conditions
Advance with us!
Skip main navigation (Press Enter).
Network Management & Authentication
Switching & Routing
Training, Documentation, & General Discussions
Switching & Routing
Back to discussions
sort by most recent
sort by thread
When using LACP with Aruba controller after a few days it became intermittent. Is there anyone exper...
Elvin, can you check the following outputs when the issue occurs and determine whether the ports ar...
Posted 05-23-2017 03:59
When using LACP with Aruba controller after a few days it became intermittent. Is there anyone experienced this ? This is my sample config
RE: lacp aruba
Posted 05-23-2017 09:58
Elvin, can you check the following outputs when the issue occurs and determine whether the ports are active/ready, if there are any link up transitions, the show log output tells us if any ports in the LAG went down to either a local or remote fault, or any errors under the LACP counters output?
This will help us isolate whether if it is a port going down or if the issue is with the LAG.
# show sharing Load Sharing Monitor Config Current Agg Min Ld Share Dist Ld Share Agg Link Link Up Master Master Control Active Algorithm Flags Group Mbr State Transitions ================================================================================ 1 LACP 1 L2 A 1 Y A 1 L2 2 Y A 0 ================================================================================ Link State: A-Active, D-Disabled, R-Ready, NP-Port not present, L-Loopback[/code]
# show lacp counters LACP PDUs dropped on non-LACP ports : 0 LACP Bulk checkpointed msgs sent : 0 LACP Bulk checkpointed msgs recv : 0 LACP PDUs checkpointed sent : 0 LACP PDUs checkpointed recv : 0 Lag Member Rx Rx Drop Rx Drop Rx Drop Tx Tx Group Port Ok PDU Err Not Up Same MAC Sent Ok Xmit Err -------------------------------------------------------------------------------- 21 21 2 0 0 0 2 0 22 2 0 0 0 2 0 ================================================================================[/code]The show log will help with any port down/up and sharing transitions.
New Best Answer
This thread already has a best answer. Would you like to mark this message as the new best answer?
LACP Counters, big difference between RX-Ok
EXOS Sharing port not in Agg Mbr
lacp with dell fx2
LACP LAG Load sharing methods
EXOS Sharing master port not added to Agg Mbr
Privacy & Terms
Copyright 2020. All rights reserved.
Site powered by
Site Design by
Powered by Higher Logic