ExtremeSwitching (EXOS)

Expand all | Collapse all

How can I configure both BGP for ipv4 and ipv6 on the same Extreme Layer 3 switches using XOS v16.2?

  • 1.  How can I configure both BGP for ipv4 and ipv6 on the same Extreme Layer 3 switches using XOS v16.2?

    Posted 10-10-2018 06:06
    How can I configure both BGP for ipv4 and ipv6 on the same Extreme Layer 3 switches using XOS v16.2?


  • 2.  RE: How can I configure both BGP for ipv4 and ipv6 on the same Extreme Layer 3 switches using XOS v16.2?

    Posted 10-10-2018 06:40
    Good morning!

    Something like this should work.

    configure bgp AS-number 12345 configure bgp add network 169.254.1.0/24 configure bgp add network address-family ipv6-unicast 2001:db8:1000:/48[/code]
    create bgp neighbor 1.2.3.4 remote-AS-number 1000
    configure bgp neighbor 1.2.3.4 source-interface ipaddress 1.2.3.5[/code]create bgp neighbor 2001:db8:f00::2 remote-AS-number 1000 configure bgp neighbor 2001:db8:f00::4 source-interface ipaddress 2001:db8:f00::5[/code]enable bgp neighbor 1.2.3.4
    enable bgp neighbor 2001:db8:f00::4 address-family ipv6-unicast[/code]enable bgp[/code]
    Assuming you have a "Provider" vlan:

    create vlan BigISP tag 999
    configure vlan BigISP ipaddress 1.2.3.5/24
    configure vlan BigISP ipaddress 2001:db8:f00::/64[/code]
    Oh, and get used to adding "address-family ipv6-unicast" to pretty much any command where you want to see ipv6 output 😉 (OK, I'm exaggerating a little - tab-completion and the "?" are your friend on the command line)

    Hope that helps