ExtremeSwitching (EXOS)

Back to discussions
Expand all | Collapse all

netlogin commands doesn't exist in command line on X440G2 v21.1.1.4

  • 1.  netlogin commands doesn't exist in command line on X440G2 v21.1.1.4

    Posted 08-23-2018 06:14
    I'm configuring netlogin on a X440G2, and some commands aren't show in the CLI

    1) the option "mode" dosn't exists
    configure netlogin ports 2:35 mode mac-based-vlans

    2) the option "vlan" dosn't exists
    configure netlogin vlan NAC-EXTREME

    * Slot-2 SW-A-1-1.54 # configure netlogin ports 2:35 (tab)
    allowed-users Number of users allowed per port
    authentication Configure port authentication settings
    trap Enable/Disable/Prohibit trap on first rule use

    * Slot-2 SW-A-1-1.54 # configure netlogin (tab)
    add Add a MAC-list entry
    agingtime Configure the time after which unauthenticated clients are removed
    allowed-refresh-failures Number of session refresh failures allowed before automatic logout
    authentication Configure Network Login client authentication settings
    banner Banner for Login Page
    base-url Base URL
    delete Delete a MAC-list entry
    dot1x Configure Network Login settings specific to 802.1X
    idle-timeout Set timeout for an idle session
    local-user Netlogin local user
    mac Configure Network Login settings specific to MAC
    ports Specify ports to add
    redirect-page Redirect Page
    session-refresh Session refresh time
    session-timeout Set timeout for an active session
    trap Set Network Login trap configuration
    web-based Configure the web-based authentication protocol


  • 2.  RE: netlogin commands doesn't exist in command line on X440G2 v21.1.1.4

    Posted 08-23-2018 07:49
    Hi Andrea,

    If policy is enabled these options will not be available.
    Please check "show configuration policy" to disable use the command "disable policy" then the options to add netlogin vlan and mode should be available.

    Regards,
    Karthik


Related Content