ExtremeSwitching (EXOS)

 View Only
  • 1.  PIM-SM

    Posted 01-07-2014 21:52
    Create Date: Mar 28 2012 11:27AM

    I am configuring PIM-SM on an Extreme 460. One vlan on the 460 will have the multicast sources, a seoncd vlan is the connection to the rest of the network and the RP. ipforwarding is enabled OSPF is used for the routing protocol. My question is if I configure a static RP do I still need to configure a CBSR (candidate bootstrap router) ? If so should it be my 460 or the the RP?



    Thanks Much!

    Ryan Moore

    (from Ryan_Moore)


  • 2.  RE: PIM-SM

    Posted 01-07-2014 21:52
    Create Date: Mar 30 2012 4:04AM

    Hi,

    I think, all you need is the following:

    1st of all, create a policy with the following content:

    entry mcast {

    if {

    } then {

    nlri *your_mcast_address*;

    }

    }



    Then configure mcast:

    enable ipmcforwarding

    conf pim add vlan *your mcast-sender vlan* sparse

    conf pim add vlan *your transfer vlan* sparse

    configure pim crp vlan " your transfer vlan " "your policy file" 0

    configure pim cbsr vlan " your transfer vlan " *priority*

    enable pim



    Now - check the configuration with *sh pim rp-set* - the mcast-address entered in you policy-file must be in list.



    best regards

    Falk



    (from Falk_Fischer)


  • 3.  RE: PIM-SM

    Posted 01-07-2014 21:52
    Create Date: Apr 2 2012 8:06AM

    Thanks Very Much Falk! That's what I was looing for.

    (from Ryan_Moore)