ExtremeSwitching (EXOS)

  • 1.  How to run this script

    Posted 02-10-2017 13:15
    how to run the below

    create qosprofile "QP5"
    #Start editor to create file#
    vi omsubnet.pol

    #Enter insert mode#
    i

    #Copy and Paste the below#
    entry QP5subnet {
    if {
    source-address 10.68.4.96/28
    }
    then {
    Qosprofile qp5;
    replace-dscp;
    }
    }
    #To this line#

    #To save#
    :wq

    #Enable DSCP replacement#
    configure access-list omsubnet.pol

    #Save#
    save



  • 2.  RE: How to run this script

    Posted 02-10-2017 13:28
    Khalid, we do have an article that walks through creating and applying an access-list in further detail:

    https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-create-and-apply-an-ACL-in-EXOS

    You would have to use your policy instead of the example in the article. Be sure to press escape and i (insert) before pasting otherwise you may miss a line.

    The policy will have to be applied to port or VLAN:

    configure access-list [port|vlan] [ingress|egress]

    You can also verify whether there are any errors in the policy using:

    check policy