ExtremeSwitching (EXOS)

  • 1.  How i configure LACP between Extreme and CISCO?

    Posted 09-24-2015 21:17
    Hi, I need configure LACP protocol between Extreme and cisco.

    i have a BD-8810 SW i need configure two ports with LACP protocol but i dont have idea... the other equipment is a Cisco. i check in the command reference guide but that not say a lot



  • 2.  RE: How i configure LACP between Extreme and CISCO?

    Posted 09-24-2015 21:23
    enable sharing grouping lacp (EXOS) Cisco: interface GigabitEthernet0/0/1 no ip address no negotiation auto channel-group 1 mode active end L3-UC#show run int gig 0/0/2 Building configuration... Current configuration : 103 bytes ! interface GigabitEthernet0/0/2 no ip address no negotiation auto channel-group 1 mode active end [/code]


  • 3.  RE: How i configure LACP between Extreme and CISCO?

    Posted 09-24-2015 21:23
    Hi Jeremy, so only i need apply this in my BD-8810. for example:

    enable sharing 1:2 grouping 1:2 1:3 lacp

    but which is the difference with

    enable sharing 1:2 grouping 1:2 1: algorithm address-based L3 lacp



  • 4.  RE: How i configure LACP between Extreme and CISCO?

    Posted 09-24-2015 21:24
    Check this guide for basic configuration in EXOS: http://packetflow.io/2015/01/extreme-networks-exos-cheat-sheet.html



  • 5.  RE: How i configure LACP between Extreme and CISCO?

    Posted 09-25-2015 00:40
    Hi Daniel,

    In addition to what Jeremy and Bernardo posted, this GTAC Knowledge article may help out as well:
    https://gtacknowledge.extremenetworks.com/articles/How_To/how-to-configure-sharing-LAG-LACP-in-Summi...

    -Brandon


  • 6.  RE: How i configure LACP between Extreme and CISCO?

    Posted 09-25-2015 01:02
    Here is also a great article about Cisco and "port-channels"

    http://www.freeccnaworkbook.com/workbooks/ccna/configuring-etherchannel-utilizing-lacp