ExtremeSwitching (EXOS)

Expand all | Collapse all

AVB disabled after reboot

  • 1.  AVB disabled after reboot

    Posted 10-23-2018 20:24
    I have a X440-G2-24t-GE4, I have installed the AVB licence using the CLI, then set up a IP for using the web browser chalet control. I enabled the AVB ports in chalet and clicked save. but when the switch is power cycled/rebooted the AVB ports are disabled upon reboot. i have to go back into the AVB config and enable them again.

    any clues as to why this is happening?


  • 2.  RE: AVB disabled after reboot

    Posted 10-24-2018 06:55
    Try....
    - enable ports via chalet
    - save config via CLI
    .... does that work ?

    What software version is running and what web browser is used, have you tried it with another PC/browser.


  • 3.  RE: AVB disabled after reboot

    Posted 11-05-2018 17:18
    I tried a different browser and same issue. config not saved via chalet after reboot.

    I found this from the Biamp website and used the CLI and Putty:

    To enable AVB on all ports, enter the following commands:

    disable flow-control rx-pause ports all

    disable flow-control tx-pause ports all

    enable avb

    enable avb port all

    disable edp port all

    save configuration

    this worked and th config was saved after a reboot.

    I have to say the Extreme Networks website and support documentation and user guides are a nightmare to find the right information and massively over complicated