Hi,
Was almost reluctant to post this question in fear the answer is likely to be obvious, but I am trying to configure a trusted DHCP server, but I can only see a per VLAN configuration statement (trusted port to one side for now). So my configuration is per below:
configure trusted-servers vlan Stack2_Data add server 192.168.200.40 trust-for dhcp-server
configure trusted-servers vlan Mgmt-Stack2 add server 192.168.200.40 trust-for dhcp-server
configure trusted-servers vlan Wireless_CorpLaptop add server 192.168.200.40 trust-for dhcp-server
configure trusted-servers vlan Security_NW add server 192.168.200.40 trust-for dhcp-server
configure trusted-servers vlan Power-Bars add server 192.168.200.40 trust-for dhcp-server
configure trusted-servers vlan AV add server 192.168.200.40 trust-for dhcp-server
configure trusted-servers vlan Legacy-Data add server 192.168.200.40 trust-for dhcp-server
configure trusted-servers vlan Legacy-Wkstns add server 192.168.200.40 trust-for dhcp-server[/code]
When I get to the next line you get the following error:
Slot-1 STK-02.30 # configure trusted-servers vlan Stack2_Voice add server 192.168.200.40 trust-for dhcp-server
ERROR: No more than 8 trusted DHCP servers can be configured across all vlans.[/code]
This is because it is seeing each statement as individual DHCP servers even though they all have the same IP?
So my questions is if there is a different way to put the command in to achieve what I need, considering I would like to eventually configure two trusted DHCP servers, and have over 8 VLANs?
Perhaps this should just be done via the trusted port method instead, but I suspect something might be wrong with my syntax.
Running a stack of 4 x X440-G2' with version 22.2.1.5
Many thanks.