ExtremeSwitching (EXOS)

  • 1.  pim register checksum

    Posted 04-22-2016 14:38
    Hi all,

    Does any one of you ever encountered problem in having error message on "PIM register-checksum" on BD8k or summit x460 switches?

    If yes, may I know how to resolve this ? Please advice.

    Best regards,
    Dennis neo



  • 2.  RE: pim register checksum

    Posted 04-22-2016 14:47
    Do
    sho config pim detail on both switches

    Make sure this line is the same on both "configure pim ipv6 register-checksum-to exclude-data"

    Could also be one of these
    configure pim register-checksum-to include-data
    configure pim register-checksum-to exclude-data


  • 3.  RE: pim register checksum

    Posted 04-22-2016 17:43
    Dennis:

    Have you taken a look at this article?

    PIM Register message failed the checksum test


  • 4.  RE: pim register checksum

    Posted 04-23-2016 12:15
    yes, but either when I applied the command include-data or exclude-data the error PIM register checksum will change from one interface to another interface IP addresses. It is therefore become very difficult for me to troubleshoot in order to get the problem resolve....


  • 5.  RE: pim register checksum

    Posted 04-23-2016 12:15
    PIM register messages are exchanged from multicast source routers (the first hop routers) to RPs.


  • 6.  RE: pim register checksum

    Posted 05-20-2016 17:01
    Hi Dennis,
    Are you still having problems with this? If so, it may be time to contact GTAC.


  • 7.  RE: pim register checksum

    Posted 05-22-2016 00:55
    Hi Kevin,
    Thank you for your respond. We will try it out on site.
    Best regards,
    Dennis neo