ExtremeSwitching (EXOS)

  • 1.  Switch denied to supply power on port

    Posted 11-07-2014 09:06
    i could not able to get the power on the port 9 and 10 where the power is working in other ports in the same line card. please find the below logs and kindly help me to resolve the same or kindly confirm is it a hardware failure

    STATISTICS COUNTERS
    Port State Class Absent InvSig Denied OverCurrent Short
    9:10 denied ------ 0 0 3 0 0




    # sh inline-power

    Inline Power System Information
    Configured : Enabled
    System Power Surplus : 2971 Watts available for budgeting
    Redundant Power Surplus : 1889 Watts available for budgeting to maintain N+1
    Power Usage Threshold : 70 percent (per slot)
    Disconnect Precedence : deny-port
    Budgeted Measured
    Slot Inline-Power Firmware Status Power (Watts) Power (Watts) Legacy
    9 Enabled Operational 50 W 32 W Disabled
    10 Enabled Operational 50 W 30 W Disabled



  • 2.  RE: Switch denied to supply power on port

    Posted 11-07-2014 09:12
    Hello If it was working and now it stopped working you might have to check show log
    to see why it stopped working.
    You might have to increase power budget if incase the slot is oversubscribed.
    Details are available in concepts guide page 431
    Power Checking for PoE ModulePoE modules require more power than other I/O modules.
    When a chassis containing a PoE module is booted or a new PoE module is inserted, the power drain is
    calculated. Before the PoE module is powered up, the chassis calculates the power budget and powers
    up the PoE module only if there is enough power. The chassis powers up as many I/O modules as
    possible with lower-numbered slots having priority.
    Note
    If your chassis has an inline power module and there is not enough power to supply the
    configured inline power for the slot, that slot will not power on; the slot will not function in
    data-only mode without enough power for inline power.
    PoE
    ExtremeXOS


  • 3.  RE: Switch denied to supply power on port

    Posted 11-07-2014 09:20
    I have seen reseating the card solves these kind of problems.
    But you might have to identify the root cause.