ExtremeSwitching (EXOS)

Expand all | Collapse all

How to create an LACP LAG on EXOS 21.1X?

  • 1.  How to create an LACP LAG on EXOS 21.1X?

    Posted 03-02-2018 16:08
    I'd like to create a simple 4 port LAG between an Extreme Switch (x460-G2) and a Brocade switch (that is already successfully setup for LACP)

    I've never setup a LACP LAG on EXOS before. Is there a guide for this?


  • 2.  RE: How to create an LACP LAG on EXOS 21.1X?

    Posted 03-02-2018 16:10
    Hello Sean,

    You follow the same procedure to create a lag and add "LACP" onto the end. Here is an article that shows this process:

    https://gtacknowledge.extremenetworks.com/articles/How_To/how-to-configure-sharing-LAG-LACP-in-Summi...

    Hope this helps!


  • 3.  RE: How to create an LACP LAG on EXOS 21.1X?

    Posted 03-02-2018 16:12
    Sean,
    you can do this with the following command:

    configure sharing


  • 4.  RE: How to create an LACP LAG on EXOS 21.1X?

    Posted 03-05-2018 01:20
    Hi Sean,
    Kindly share the good discussion about this topic in our Hub.

    https://community.extremenetworks.com/extreme/topics/how-i-configure-lacp-between-extreme-and-cisco

    Best regards