ExtremeSwitching (VSP)

Expand all | Collapse all

VOSS "Default" command

  • 1.  VOSS "Default" command

    Posted 07-11-2018 12:56
    What about the "default" command in VOSS ?

    I see this command at interfaces, MLT, etc. and at global command level.

    Here an example (VSP7200 - V7.0.0):
    [/code]SW11:1(config-mlt)#?
    default Default settings [/code] ... [/code]SW11:1(config-mlt)#default ?
    Default settings
    flex-uni Set flex-uni to default on mlt interface
    ip
    isis set interface level isis parameters to default value
    lacp Set lacp for specific mlt to default
    smlt Create default smlt on a specific mlt
    svlan-porttype Set svlan port type to default
    virtual-ist Create virtual-ist on MLT with default value [/code]SW11:1(config-mlt)# [/code]
    Unfortunately i do not find any manual where this command or the usage will be explained. CLI Reference does not explain this command.

    Do anyone tell me which VOSS manual explain the usage ?? Or have anyone an example how to use this command ?

    Regards


  • 2.  RE: VOSS "Default" command

    Posted 07-11-2018 14:13
    It restores a setting to its default value (i.e value it would have under switch factory defaults)


  • 3.  RE: VOSS "Default" command

    Posted 10-20-2018 08:44
    default command operator You can reset the modified configuration of a command to the default configuration by using the

    default operator. For more information about the default value for each command, see CLI

    Commands Reference.

    Use the ? command completion along with the default keyword in each configuration mode, to view

    the list of commands that support the default operator. For more information, see Command

    completion on page 15.

    Example

    Configure csnp-interval to its default value. The default value of csnp-interval is 10

    seconds.



  • 4.  RE: VOSS "Default" command

    Posted 07-11-2018 14:13
    Does the value restore to "factory" default or can i define a custom default value ?
    Do you know which manuel does explain that ?


  • 5.  RE: VOSS "Default" command

    Posted 07-11-2018 14:13
    Restores value to factory default. No, you cannot define a custom default value."default" and "no" are standard command modifiers which can precede CLI configuration commands, to default or negate a config setting.This is supposed to be Cisco-like.I guess it should be in the Using CLI guide, but seems not to be there...


  • 6.  RE: VOSS "Default" command

    Posted 07-11-2018 14:13
    here is where the default operator is explained: starting on page 17. I hope this helps.