ExtremeSwitching (EOS)

Expand all | Collapse all

How to Configure Dynamic LAGs with LACP on Summit x690 vs S-Series? Is this possible to do?

  • 1.  How to Configure Dynamic LAGs with LACP on Summit x690 vs S-Series? Is this possible to do?

    Posted 11-23-2018 21:53
    Hi community,

    It is possible to configure Dynamic LAG's with LACP between Summit x690 and S4 S-Series?

    What is the correct way to do it?

    Regards,


  • 2.  RE: How to Configure Dynamic LAGs with LACP on Summit x690 vs S-Series? Is this possible to do?

    Posted 11-24-2018 12:34
    Hi Cristian,

    Is is possible. In EXOS you don't care about keys, that's the difference:
    enable sharing X port X-Y lacp[/code]Where X is 'master port' (typically the first port of your lag, when you add LAG to a VLAN you just add X to that VLAN).
    I would then do 'show lacp lag X' to see what partner admin key should be set on S-Series aggregation if you want to specify it.
    'Show sharing' shows you if your aggregation is fine.

    Hope that helps,
    Tomasz


  • 3.  RE: How to Configure Dynamic LAGs with LACP on Summit x690 vs S-Series? Is this possible to do?

    Posted 11-25-2018 01:31
    Summit enable sharing 25 group 25-26 lacp 25 is the lead port To check status show port sharing Example:

    code:
    * X150-24p.41 # show port sharing
    Load Sharing Monitor
    Config Current Agg Ld Share Ld Share Agg Link Link Up
    Master Master Control Algorithm Group Mbr State Transitions
    ==============================================================================
    25 LACP L2 25 - R 0
    L2 26 - R 0
    ==============================================================================


  • 4.  RE: How to Configure Dynamic LAGs with LACP on Summit x690 vs S-Series? Is this possible to do?

    Posted 11-29-2018 00:00
    Hi community,

    Thanks for your help.

    When I have the opportunity to try, I tell them what happened.

    Regards,

    Cristian