ExtremeSwitching (Other)

Expand all | Collapse all

Configuration IP ADDRESS on Enterasys for a VLAN

  • 1.  Configuration IP ADDRESS on Enterasys for a VLAN

    Posted 09-12-2017 20:31
    Hi everyone

    I'm a noob with Enterasys sws. Please need your help

    We've 6 switchs (2 Cisco and 4 Enterasys A2) every switch is in a different IDF, We ́re in the segmentation process and we're created a VLAN 20 for Switchs Management, with the cisco we don't have any problem, but with Enterasys we don't have idea how to configure a IP ADDRESS in VLAN 20 to reach every Enterasys under this VLAN 20

    Please somebody help me!


  • 2.  RE: Configuration IP ADDRESS on Enterasys for a VLAN

    Posted 09-12-2017 22:45
    Are you running your management in vlan 20?

    Try

    set host vlan 20


  • 3.  RE: Configuration IP ADDRESS on Enterasys for a VLAN

    Posted 09-12-2017 22:53
    Yes, the management is in vlan 20!! 🙂


  • 4.  RE: Configuration IP ADDRESS on Enterasys for a VLAN

    Posted 09-12-2017 22:53
    Did that work?



  • 5.  RE: Configuration IP ADDRESS on Enterasys for a VLAN

    Posted 09-13-2017 01:23
    If you have different switches with VLANs and want to connect them together you have to set the egress state of the ports where the switches are connect together:
    example: Switch A is connected with Switch B (let's say the uplink port between both is ge.1.1 then you have to:
    - create the VLAN : set vlan create 20
    - configure Data Host Port into vlan 20: set host vlan 20
    - configure ge.1.1 to forward vlan 20 traffic tagged: set vlan egress 20 ge.1.1 tagged
    - configure the ip address on both switches: set ip address 10.0.0.1 mask 255.0.0.0 gateway 10.0.0.254
    At the cisco - I'm not sure - but I guess you have to set the port in trunk mode and allow vlan 20.

    If you configure two Enterasys switches like the example and connect them together it should be possible to ping from one to the other.
    Best regards,
    Axel


  • 6.  RE: Configuration IP ADDRESS on Enterasys for a VLAN

    Posted 09-15-2017 08:18
    On the A2's you can confirm the up link port settings by running the command Show vlan portinfo port por# The port may be assigned to vlan 1 untagged and vlan 20 tagged on egress So if you want to have both assigned to 20 First do set port vlan port# 20 modified-egress And follow the steps above from Axel Then again run the show vlan portinfo port port# to confirm your settings