ExtremeSwitching (Other)

  • 1.  Uploading config to already working stack....

    Posted 05-29-2015 20:37
    I am new to stacking; But, a master node of the stack went down this week. It was replaced enough to get it working with most of the config present but not all. Remotely I have been tasked with uploading a backed up known working config. Do I need to use any other commands minus
    the

    tftp get blah blan blah

    file xfer command. I have uploaded many a config, but never to a stack.

    Model is x45a-24t, all bootroms and versions are the same in the stack.

    ty


  • 2.  RE: Uploading config to already working stack....

    Posted 05-29-2015 20:43
    Hi Jimmy,
    If the config you have saved is actually the XML formatted config and not a "plain-text" script-ready config, then simply transferring the config over with TFTP is all you should need to do.
    Once it's copied to the stack master (double check with the
    code:
    ls
    command), enter
    code:
    use config (filename)
    to set it active.
    code:
    Reboot
    , but DO NOT SAVE - If you do, you'll overwrite that new config with whatever is currently on the switch. When the stack comes back up, it should be loaded with the new configuration you just downloaded.

    -Drew


  • 3.  RE: Uploading config to already working stack....

    Posted 05-29-2015 20:45
    Once it is loaded to the stack the only other command you would need is "
    code:
    use configuration (filename)
    ". Then a reboot will be needed. Here is an article that explains:

    Browser View: https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-copy-a-configuration-to-a-new-switch


  • 4.  RE: Uploading config to already working stack....

    Posted 05-29-2015 20:45
    Thank you both. Worked out perfectly, and the site has a working config :)


  • 5.  RE: Uploading config to already working stack....

    Posted 06-02-2015 08:23
    Just a remark, normally in a stack a backup slot would take over the master role when the master slot fails. If it did not do that probably the other slots are not master capable, maybe something worth checking and changing ?

    Replacing a node in a stack would not be difficult if following this procedure;
    https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-replace-a-node-in-a-SummitStack