ExtremeWireless (Identifi)

  • 1.  shell command to check ARP table

    Posted 01-08-2016 12:00
    Hi,

    I just troubleshoot a problem and need the command to check the ARP table of the controller.

    #arp doesn't give me much info...

    root@XXX:~# arpAddress HWtype HWaddress Flags Mask Iface
    10.4.103.254 ether 00:00:0c:07:ac:00 C eth0
    10.4.103.251 ether 78:2b:cb:3a:90:c9 C eth0
    10.4.103.223 ether 00:22:4d:67:f3:91 C eth0
    10.4.103.224 (incomplete) eth0
    root@XXX:~#

    I'd need it to check the MAC/IP of the APs on a bridge@EWC interface.

    Thanks,
    Ron


  • 2.  RE: shell command to check ARP table

    Posted 01-08-2016 13:53
    I don't specifically know of a command to grab the arp table for the esa port, it's not something we expose via the shell. If you do need this, you should open a GTAC ticket. Shell commands are used for support and debugging so we typically wouldn't post them here on a public forum.

    Regards,

    Doug


  • 3.  RE: shell command to check ARP table

    Posted 01-08-2016 14:03
    Thanks Doug,

    here my ticket# 01180187

    -Ron