ExtremeWireless (Identifi)

  • 1.  Wireless enterasys access point WS-AP3610

    Posted 09-01-2016 12:29
    Good day All



    my company have buy new AP3610, I need to set it up and add to the exiting access point, all are enterasys access point WS-AP3610.

    And this is my first time configure new AP. This AP comes with no manual like give basic set up and give IP address for management.

    I have search and found default IP address of 192.168.10.1/24 and this IP address is not working .

    I have tried to configure it with following configure



    cset ipaddr 192.168.10.3

    cset ipmask 255.255.0.0

    cset gateway 192.168.10.2

    capply

    csave

    (Wait until the prompt comes back)

    reboot



    however when I test if I can ping this IP address , I’m getting this error

    # ping 192.168.10.3

    PING 192.168.10.3 (192.168.10.3): 56 data bytes

    ping: sendto: Network is unreachable





    can someone help me .


  • 2.  RE: Wireless enterasys access point WS-AP3610

    Posted 09-01-2016 16:56
    You need a controller to use this AP.


  • 3.  RE: Wireless enterasys access point WS-AP3610

    Posted 09-01-2016 19:40
    - you need to disable DHCP first or the static entry will not work
    # cset dhcp disable

    - as Jeremy mentioned > you need an WLAN controller to configure the other settings

    - in my opinoin you should hire someone to install the APs and give you a basic training
    you could find partners here > http://www.extremenetworks.com/partners/
    or training > http://www.extremenetworks.com/education/courses/ESE-HI-1/


  • 4.  RE: Wireless enterasys access point WS-AP3610

    Posted 09-01-2016 19:40
    Thanks Ronald


  • 5.  RE: Wireless enterasys access point WS-AP3610

    Posted 09-01-2016 19:40
    no problem - did it work with the DHCP disable command ?


  • 6.  RE: Wireless enterasys access point WS-AP3610

    Posted 09-02-2016 03:12
    The AP3610 does require controller for configuration and monitoring. When the AP is configured the controller is not needed (some exceptions are there). The controller must be version 9.X maximum. The version 10 is not compatible with AP3610. As Ronald mentioned the help from trained/experienced person is good way to go.


  • 7.  RE: Wireless enterasys access point WS-AP3610

    Posted 09-02-2016 05:08
    It´s year 2016 und you purschased =>new<= AP3610 access points? Hint: They are rather old and software version 9.* will be the last major software release for them. You cannot use version 10.x and up