Skip to main content (Press Enter).
Skip auxiliary navigation (Press Enter).
Terms and Conditions
Advance with us!
Skip main navigation (Press Enter).
Network Management & Authentication
Switching & Routing
Training, Documentation, & General Discussions
Back to discussions
Posted 12-27-2018 20:47
I'm having an issue with the VX 9000 it just happen last month I was trucking along adding AP through DHCP and then plugging in the AP7562 just fine it would up date the firmware then one day after I enter information into DHCP and plug AP into POE it wouldn't register any more in VX also i would check the logs and see a error start upgrade failed any insight or direction would be very helpful
New Best Answer
This thread already has a best answer. Would you like to mark this message as the new best answer?
computer plugged into phone
RE: Getting started with VX 9000
Pluggable Transceiver Specifications datasheet
B5 detects unsupported pluggable module
Is stacking module support hot plug?
Privacy & Terms
Copyright 2020. All rights reserved.
Site powered by
Site Design by
Powered by Higher Logic