ExtremeWireless (Identifi)

Expand all | Collapse all

EWC C5110-2 Ports doesn't come up.

  • 1.  EWC C5110-2 Ports doesn't come up.

    Posted 12-20-2017 08:13
    EWC C5110-2 esa port doesn't come up.

    1.checked the Admin status of the ports on both the end (switch as well as controller).Still the port shows down.



  • 2.  RE: EWC C5110-2 Ports doesn't come up.

    Posted 12-20-2017 08:28
    Hi Mohammed,

    Has the port been configured?

    https://gtacknowledge.extremenetworks.com/articles/Q_A/Using-the-Console-Port-on-the-IdentiFi-Wirele...

    Is the cable being used known to be good?

    Is this apart of an existing network or yet to be commissioned?

    - Sam



  • 3.  RE: EWC C5110-2 Ports doesn't come up.

    Posted 12-20-2017 08:38
    Hi Sam

    This controller is already in used.Esa0 is being used and its working fine.
    Now I want to use esa1 for the captive portal traffic so when I connected this with switch it is not coming up.



  • 4.  RE: EWC C5110-2 Ports doesn't come up.

    Posted 12-20-2017 09:37
    Hi Mohammed,

    If you've confirmed the cable and switch ports are good, configured a topology in the GUI for esa1 and there is still no luck then i would advise opening a case with us here at GTAC.

    - Sam


  • 5.  RE: EWC C5110-2 Ports doesn't come up.

    Posted 12-20-2017 10:34
    Let's start with the most basic question - which of the below ports have you connected ?
    esa1 = #2 = the fibre port



    Is the esa1 enabled on the controller GUI > Controller > Network > L2 Ports > checkmark for esa1 is set and it's not in a LAG

    -Ron


  • 6.  RE: EWC C5110-2 Ports doesn't come up.

    Posted 12-20-2017 10:45
    Hi Ronald



    Attached is the controller GUI L2Ports status esa1 is enable and the cable is connected.
    It is not the part of the Lag.



  • 7.  RE: EWC C5110-2 Ports doesn't come up.

    Posted 12-20-2017 10:52
    What LAN switch is used and is the fiber port a 10G port ?
    Try out esa2 - at least the L2 should go green even without a configuration on the controller.
    Have you checked whether rx/tx of the fiber link is correct.


  • 8.  RE: EWC C5110-2 Ports doesn't come up.

    Posted 12-20-2017 11:05
    Hi Ronald

    LAN switch is Enterasys B5K series and yes the fiber between B5k and core is 10Gig
    Tried on all the available ports but no luck.
    Yes verified port speed and duplex on both the ends.



  • 9.  RE: EWC C5110-2 Ports doesn't come up.

    Posted 01-18-2018 13:14
    I would suggest you contact the GTAC for more assistance on this issue. https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-contact-Extreme-Networks-Global-Tec...