ExtremeWireless (WiNG)

Expand all | Collapse all

How do we change the IP address of Slave AP(WING AP-7522) from Virtual controller(WING AP-7522)?

  • 1.  How do we change the IP address of Slave AP(WING AP-7522) from Virtual controller(WING AP-7522)?

    Posted 09-04-2018 10:06
    Is there any possibility to change the IP address of Slave AP from the Virtual controller



  • 2.  RE: How do we change the IP address of Slave AP(WING AP-7522) from Virtual controller(WING AP-7522)?

    Posted 09-04-2018 10:25
    Yes, and here's how:

    1 - SSH into the the virtual controller and run the following commands:
    >en
    #conf t
    #host
    #int vlan
    #ip address (e.g. 10.0.0.1/8)
    If you would like to retain the Zero config (secondary) IP address add the following line:
    #ip address zeroconf secondary
    #com wr

    If you'd like to do this from GUI I would need to know if you're using the Swift or Enterprise UI.



  • 3.  RE: How do we change the IP address of Slave AP(WING AP-7522) from Virtual controller(WING AP-7522)?

    Posted 09-04-2018 10:25
    We are using enterprise UI


  • 4.  RE: How do we change the IP address of Slave AP(WING AP-7522) from Virtual controller(WING AP-7522)?

    Posted 09-04-2018 10:25
    On VC, go to Configuration >> Devices >> Device Overrides >> Select an AP from list >> Edit >> Interfaces >> Virtual Interfaces >> Select VLAN >> Edit >> IPV4 >> IPV4 IP addresses >> Uncheck: Use DHCP to obtain IP >> Enter static IP address in Primary IP address field >> Enable Zero Configuration: Secondary (optional) >> OK >> Exit >> Commit and Save.