ExtremeWireless (WiNG)

Expand all | Collapse all

How to create Virtual Controller redundancy

  • 1.  How to create Virtual Controller redundancy

    Posted 08-03-2018 12:28
    HI all,

    I am using AP 7532 & AP 7522E, Both firmware are 5.9.2. can i create vc redundancy for these both AP's? possible means guide me. now AP 7532 is a virtual Controller.


  • 2.  RE: How to create Virtual Controller redundancy

    Posted 08-03-2018 14:31
    This should be supported, but we currently have a known issue with the AP7522E being converted via upgrade to v5.9.2:

    AP7522E v5.9.2.1 ignores adopt request from regular sku AP75xx with the following message.

    Jul 24 15:10:10 192.168.3.158 2018-07-24T15:12:17.010422-07:00 AP7522VC DPD2: 2018-07-24 15:12:17 mlcp.c:946 mlcp_handle_discover Ignoring discover from non-WiNG Express device

    We have SPR (Software Problem Report) #3484 against this issue and issue will be resolved in a future v5.9.x release.

    For the time being, I would not configure an AP7522E v5.9.2 as VC redundant until we resolve SPR #3484.


  • 3.  RE: How to create Virtual Controller redundancy

    Posted 08-03-2018 16:01
    I tried that link basis. but i dont know where it is Option for RF Domain Manager.



  • 4.  RE: How to create Virtual Controller redundancy

    Posted 08-03-2018 16:13
    As Chris Frazee mentioned, you might want to hold off on configuring the AP7522E as VC redundant, until SPR #3484 is resolved.

    But to answer your question, the setting is at the bottom of the General page:




  • 5.  RE: How to create Virtual Controller redundancy

    Posted 02-07-2019 10:25
    Hi
    is SPR #3484 is resolved yet does this apply to the AP7532, @ FW5.9.2.1
    Is there a setup guide / best practice guide ?


  • 6.  RE: How to create Virtual Controller redundancy

    Posted 02-07-2019 16:52
    Fix for SPR #3484 is in WiNG v5.9.3.0 and higher.


  • 7.  RE: How to create Virtual Controller redundancy

    Posted 02-07-2019 16:54
    OK,
    just waiting for our GTAC+ to be setup so I can get access to the FW for the AP's on support

    Thanks


  • 8.  RE: How to create Virtual Controller redundancy

    Posted 02-07-2019 16:58
    No problem Phil and documentation is located where firmware is on the Extreme Portal.


  • 9.  RE: How to create Virtual Controller redundancy