ExtremeWireless (WiNG)

  • 1.  How to configure GE port of wing controller VX9000?

    Posted 08-08-2018 06:22
    Hi,

    I have one doubt, my controller IP is 10.4.4.41/22 with VLAN 14 and my data VLAN is 18.controller is running on VMware platform with only one GE port.so how to configure ge1 port of controller?

    Please find the below settings, this is correct or not

    Native VLAN 14 with IP:10.4.4.41/22
    Mode : Trunk
    Allowed VLAN: 18,20,22,24,33,34

    Thanks
    Niyas P


  • 2.  RE: How to configure GE port of wing controller VX9000?

    Posted 08-08-2018 06:30
    Hi!
    I'm not sure about that... Niyas
    it's in the AP profile that the ports have to be in trunk mode
    not on the controller.
    The flow goes through the APs.
    as the example below

    profile ap7522 default-ap7522
    ge1 interface
    switchport mode trunk
    switchport trunk native vlan 1
    no switchport trunk native tagged
    switchport trunk allowed vlan 1,4,14



  • 3.  RE: How to configure GE port of wing controller VX9000?

    Posted 08-08-2018 06:36
    Hi,

    Please find the below screenshot.This is the controller GE port





  • 4.  RE: How to configure GE port of wing controller VX9000?

    Posted 08-08-2018 08:40
    The vx9000 does not have a data plane so no user data is tunnelled via vx9000, user data should be bridged on the access points as explained in the earlier post The port on the VX should therefore be set as access on vlan 1 This port is then bridged to the virtual switch within VMware The VX only requires a single vlan and single IP address This interface is for control traffic only. Please note if this interface is changed the vx9000 will require to be relicensed. Regards Andy


  • 5.  RE: How to configure GE port of wing controller VX9000?

    Posted 08-08-2018 09:21
    Hi,

    Suppose my management VLAN is 14 and IP address 10.4.4.41/22.I need to set only this VLAN and IP address in GE1 port?.and what about virtual interfaces?

    Thanks
    Niyas P



  • 6.  RE: How to configure GE port of wing controller VX9000?

    Posted 08-08-2018 09:21
    Hello Niyas,

    For what you need these additional VLANS on VX?

    Aviv