ExtremeWireless (WiNG)

Zebra ap 7622, ge1 port disabled. How do I factory reset the device?

Please connect to the Console port and type

# erase startup config

Hi Gihan,

please find GTAC knowledge article describing How to factory default WiNG devices

Also, be careful configuring VLANs and LAN ports via SwiftUI as described in this thread

Regards,
Ondrej

Connect via serial (19200 or 115200) and login with:
user: reset
password: FactoryDefault

was the AP adopted by a controller? If yes, it should reboot 10-15 minutes and come up with a config error.

Hello Gihan,

Here's another link with instructions on resetting the AP: How to factory reset the config of a WiNG AP from CLI

Regards,

Chris

Hi Gihan,

To reset the AP7622 to factory settings you will need console access, and log in with the following credentials:

User name: restore

Password: FactoryDefault

You can find more information on the following GTAC article:

How to factory reset the config of a WiNG AP from CLI

Regards,

Daniel.

Thank you. I will try

No. It is not adopted to controller.

I tried to using console cable with "reset" credential, but it given error "login failure"

This works only 15 minutes after the boot. Try to reboot the AP and than login.

Thank you

Thank you

Is that user name is correct..? I heard username is "reset". K I will try with this. Thank you.