ExtremeWireless (WiNG)

  • 1.  AP 3825! CLI

    Posted 03-30-2017 09:00
    Hi, I have an AP were i would like to check the connected clients via CLI (not in the controller),
    I log in via SSH and with admin user into the AP and i get a prompt just like this '#' and im not able to see available commands. however i found out that by typing CLI i can enter CLI mode, but many of the commands are not working.

    If i type in the CLI "show wlan-clients summary" i get this

    Wireless LAN Client Summary
    Host,User/ MAC Address/ IP Address Service/
    Status BSSID Radio Policy
    ===========================================================================
    doStatSrv Send Error, rc = -6
    reply message 0 bytes is too short

    the same happens with any other command where i get always the same error

    "show radio 1"

    doStatSrv Send Error, rc = -6
    reply message 0 bytes is too short

    Why this CLI doesnt work? do i need extra configuration to put it to work, where can i found documentation for the CLI and for '#' mode?


  • 2.  RE: AP 3825! CLI

    Posted 03-30-2017 09:12
    Add the " on (domain name) after the command.


  • 3.  RE: AP 3825! CLI

    Posted 03-30-2017 09:12
    on the # put in cget or cset and return to see the available get (=show) or set (=configure) commands


  • 4.  RE: AP 3825! CLI

    Posted 03-30-2017 09:20
    You'd get MU (=mobile unit = client) information with the follwing commands.

    # cget muInfo wifi0
    # cget muInfo wifi1

    wifi0/1 is the radio of the AP.