ExtremeWireless (WiNG)

Hi Team,

Actually, I am doing initial configuration with individual AP and PC without a controller,

So, what are the steps needed to configure AP without a controller, only IP setting?

Regards

NIyas P

Hi

The initial step will be lo log into the WEB INTERFACE.

The APs ge1 port is configured as an ACCESS port utilizing DHCP to obtain an I/P

Wing Express does not allow CLI configuration updates.

Once you are in the AP, you can then set it to a Static I/P

Depending on the release, there is a configuration guide that will lead you through a basic configuration

Hi there,

Here's the Quick Reference Card for this AP: https://documentation.extremenetworks.com/ExtremeWireless/AP7502_WALLPLATE_IG_MN001385A01_REVD_EN.pdf

The relevant section is Basic Ap-7502 Configuration:
To provide the Access Point with a basic configuration and access WiNG management functions, open a browser and enter the IP address printed on the serial label on the Access Point: https://[i].

Log in to the system using the default username (admin) and password (admin123).
1. On the Configuration -> Basic Settings screen, enter the AP Name and Country Name.2. On the Configuration -> Wireless screen, enter the desired Name, SSID, Security, and WPA2 Key parameters.

Also, here's the latest WiNG Express User Guide. AP Configuration starts on page 9: https://documentation.extremenetworks.com/ExtremeWireless/WING_EXPRESS_5.8_UG_MN002231A01_EN.pdf

Hope that helps!

If running WiNG v5.9 on Express AP, the following link is the latest Express User Guide for v5.9.x:

https://documentation.extremenetworks.com/WiNG/5.9.0/9035125_WiNG_Express_5_9_UG.pdf