ExtremeWireless (WiNG)

 View Only
  • 1.  Monitor AP4610 values via SNMP?

    Posted 10-08-2015 10:43
    Hello

    How can I monitor the following values of an AP4610 Extreme access point via SNMP?
    - Number of devices currently connected
    - Traffic on radio interfaces (Mbit)
    - Mode and speed of the 2.4 ghz and 5 ghz radio interface

    Many thanks in advance!

    Lukas


  • 2.  RE: Monitor AP4610 values via SNMP?

    Posted 10-08-2015 23:52
    Lukas,

    The following OIDs may help:

    -- 1.3.6.1.4.1.1916.2.131.50.1.4.3.2.11.1.1.12
    "Traffic Utilization Index

    Measures the efficiency the medium under consideration
    is used. It is the percentage of the current data throughput
    over the theoretical data rate limit, which is derived
    the current maximum physical rate configured over the medium
    based on past empirical data. This index could assist end user
    in site planning and expansion. The numerical value might be
    further classified as:
    -1: no data available ( e.g. radio is not in wlan operation
    mode )
    0-20 : very low utilization
    20-40: low utilization
    40-60: moderate utilization
    60 and above: high utilization

    -- 1.3.6.1.4.1.1916.2.131.50.1.3.33.2.1.5
    "The rf-mode of operation for the radio.
    Values:
    2.4GHz-wlan
    5GHz-wlan
    sensor


    Let me know the results.

    Thanks!


  • 3.  RE: Monitor AP4610 values via SNMP?

    Posted 10-09-2015 00:01
    Hi Lukas,

    The SNMP tool which we talking about is Netsight or ridgeline ?

    Thanks,
    Suresh.B