ExtremeWireless (WiNG)

Expand all | Collapse all

GUI Interface on AP7522E

  • 1.  GUI Interface on AP7522E

    Posted 08-01-2017 14:06
    I am unable to connect to the GUI on the access points connected to a VC, i can connect to the VC but one of the installation tests that we carry out is ensuring that we can browse to the non VC access points. It is an Express access point installation the firmware level is 5.8.5.0-016R


  • 2.  RE: GUI Interface on AP7522E

    Posted 08-22-2017 11:20
    Once AP is adopted to controller or Virtual controller, UI access to AP is disabled.. this is by design.


  • 3.  RE: GUI Interface on AP7522E

    Posted 08-22-2017 11:22
    Hi James,
    I'm running a VC network using WiNG AP7622s.
    I can connect to any of the APs providing I force a HTTPS connection. HTTP just times out.
    Have you tried HTTPS?
    Many thanks,
    Darrel.


  • 4.  RE: GUI Interface on AP7522E

    Posted 08-22-2017 11:25
    When an Express AP is adopted to a Controller/VC, it assumes the adopted APs will be managed by the controller. By design, any GUI access will be redirected back to the Controller/VC. Although you cannot access the individual APs GUI interface, you can access the APs CLI interface


  • 5.  RE: GUI Interface on AP7522E

    Posted 08-22-2017 11:27
    James, If the purpose of the test is to verify connectivity to the other APs, then the simple fact that they are adopted should be good enough.


  • 6.  RE: GUI Interface on AP7522E

    Posted 08-22-2017 11:31
    Alternative test that can be done on the adopted APs is a CLI connectivity.


  • 7.  RE: GUI Interface on AP7522E

    Posted 08-22-2017 11:37
    Bear in mind that you cannot make any config changes to Express APs from CLI.


  • 8.  RE: GUI Interface on AP7522E

    Posted 08-22-2017 12:07
    APs adopted by a VC are to be managed by the VC. Therefor GUI access to adopted APs is disabled.



  • 9.  RE: GUI Interface on AP7522E

    Posted 08-22-2017 12:26
    Just to add you can check the status of the adopted APs from the VC by going to Configuration-Access Points. This should list all of the APs adopted and their 'online' or 'offline' status.


  • 10.  RE: GUI Interface on AP7522E

    Posted 02-27-2018 06:56
    you can re enable it using CLI