Network Architecture & Design

 View Only
  • 1.  MLAG configuration between two Black Diamond

    Posted 04-26-2017 10:41
    create mlag peer "CORE-A" configure mlag peer "CORE-A" ipaddress 199.199.199.1 vr VR-Default

    configure mlag peer "CORE-A" interval 1000

    enable mlag port 10:47 peer "CORE-A" id 20

    enable mlag port 10:48 peer "CORE-A" id 10

    What does above configuration mean ?



  • 2.  RE: MLAG configuration between two Black Diamond

    Posted 04-26-2017 12:13
    Hi,

    this is the typical minimal MLAG config.

    # Name of the other MLAG peer, to distinguish if several MLAG peers are present
    create mlag peer "CORE-A"

    # IP address of the remote peer on the ISC vlan. Must not be routed
    configure mlag peer "CORE-A" ipaddress 199.199.199.1 vr VR-Default

    # the MLAG Id per port, must be identical on each MLAG peer for the same end-system
    enable mlag port 10:48 peer "CORE-A" id 10
    enable mlag port 10:47 peer "CORE-A" id 20

    You also need to have the ISC vlan created with the correct IP address and all the necessary LAG created (10:48, 10:47) with LACP if needed.

    Best Regards,
    Stephane