Skip to main content (Press Enter).
Skip auxiliary navigation (Press Enter).
Terms and Conditions
Advance with us!
Skip main navigation (Press Enter).
Network Management & Authentication
Switching & Routing
Training, Documentation, & General Discussions
Network Architecture & Design
Back to discussions
sort by most recent
sort by thread
I am sending PFC frames with priorities 0-7. when i send Pause frames for priorites 0-3 only the tar...
It looks that this is a duplicate of https://community.extremenetworks.com/extreme/topics/in-pri...
Posted 10-11-2016 11:37
I am sending PFC frames with priorities 0-7. when i send Pause frames for priorites 0-3 only the targeted priority stop. But when i send PAUSE for the rest all the traffic stops. The configuration is the same as i copied it from one priority to other so there can be no config miss match
. what can be the reason for this behavior?
RE: priority 4,5,6
Posted 10-13-2016 05:38
It looks that this is a duplicate of
New Best Answer
This thread already has a best answer. Would you like to mark this message as the new best answer?
Privacy & Terms
Copyright 2020. All rights reserved.
Site powered by
Site Design by
Powered by Higher Logic