FAQs

Configuring SecureStack CiscoDP for VLAN Advertisement to IP Phones

  • 1.  Configuring SecureStack CiscoDP for VLAN Advertisement to IP Phones

    Posted 12-31-2013 18:18
    Article ID: 5831

    Products
    SecureStack C3
    Firmware 1.00.35 and higher
    SecureStack C2
    Firmware 5.00.28 and higher
    SecureStack B3
    Firmware 1.00.29 and higher
    SecureStack B2
    Firmware 4.00.22 and higher
    SecureStack A2
    Firmware 2.00.00.0012 and higher

    Related to
    CiscoDP
    IP Phone

    Goals
    Sample configuration

    Solution
    CiscoDP may be used to communicate VLAN information to an attached IP Phone, when configured as shown below.

    code:
    set ciscodp state enable

    code:
    set ciscodp timer 10

    code:
    set ciscodp port status enable vvid
    <[code]vlan_ID[/code]> <[code]port_string[/code]>

    The reduced timer setting is so that the phone will know of its intended VLAN before it attempts DHCP. It will thus specify the proper VLAN in its 802.1Q tags, for all its communication. The untagged data from any phone-attached PC will be unaffected by this configuration, and will use the port's PVID setting for its VLAN assignment.

    For more CiscoDP configuration options, please refer to the Configuration Guide.