FAQs

 View Only
  • 1.  set speed and duplex command

    Posted 03-27-2014 14:24
    I'm looking for the command to set the speed and duplex on an Enterasys port (100mbps full and 1gbps full) does anyone know the syntax and/or able to give me an example or point me to a good resource? Thanks in advance


  • 2.  RE: set speed and duplex command

    Posted 03-27-2014 14:27
    Hi Justin, I believe these are the commands you're looking for:

    set port duplex ge.1.48 full

    set port duplex ge.1.48 half

    set port speed ge.1.48 1000

    set port speed ge.1.48 100



  • 3.  RE: set speed and duplex command

    Posted 03-27-2014 14:29
    Perfect. Thanks Tyler.


  • 4.  RE: set speed and duplex command

    Posted 04-02-2014 14:31
    If you wanted to hard set a port to 100 meg full duplex you would issue the following 3 commands:

    set port speed ge.1.1 100
    set port duplex ge.1.1 full
    set port negotiation ge.1.1 disable



  • 5.  RE: set speed and duplex command

    Posted 04-04-2014 16:06
    Go with Caution.
    For 1000BASE-T auto-negotiation are mandatory.

    From: http://en.wikipedia.org/wiki/Gigabit_Ethernet
    Autonegotiation is the Requirement for Using 1000BASE-T [9] according to Section 28D.5 Extensions required for Clause40 (1000BASE-T). [10]