End of Service Products

Expand all | Collapse all

Enterasys transceivers on extreme switches

  • 1.  Enterasys transceivers on extreme switches

    Posted 11-12-2015 07:55
    Hi ,

    I want to use the below transceivers on the extreme summit switches. If yes on which which summit switches.

    MGBIC-LC-09

    MGBIC-LC-01

    Thanks

    Syed



  • 2.  RE: Enterasys transceivers on extreme switches

    Posted 11-12-2015 21:52
    Syed Arshad,

    It is possible that these Gigabit transceivers will work on EXOS switches; however, if possible put the optic in an EXOS switch and with a cable connected run the following command and provide the output.

    debug hal show optic-info ddmi port

    This output will provide some additional output.


  • 3.  RE: Enterasys transceivers on extreme switches

    Posted 11-13-2015 16:26
    I do not have them with me.

    Did you try using them and they worked fine ?



  • 4.  RE: Enterasys transceivers on extreme switches

    Posted 02-08-2017 10:17
    There was a display issue is earlier firmware that would report "not supported " on some transceivers but that has been addressed so it is always a good point to upgrade but if the traffic passes without any issues you should be good to go.


  • 5.  RE: Enterasys transceivers on extreme switches

    Posted 05-20-2017 01:02
    The release notes are the go to documentation for these questions. If it is listed in a release as supported then it should be. If there are issues let us know.


  • 6.  RE: Enterasys transceivers on extreme switches

    Posted 11-13-2015 16:26
    You should try them yourself, in most cases 3rd party transceivers work well