ExtremeCloud IQ- Site Engine & Extreme Management Center

 View Only
  • 1.  XMC - System Variables

    Posted 02-28-2018 20:02

    there are a lot of system variables in XMC for scripting. I test some of the variables with python on XMC together with an xos switch. All works fine.

    But the variable $STATUS returns always 1 no matter the command works or not.

    Here is the description from the manual:

    "$STATUSThe execution status of the previously executed ExtremeXOS command: 0 if the command executed successfully, non-zero otherwise."

    I tried the following in python:

    cli_result = emc_cli.send("create vlan test")
    check = emc_vars["STATUS"]
    print check
    The result for print check allways 1 no matter if I do the command one time or twice.

    If I do the command only once the VLAN was created => I expected the value "0" for STATUS

    If I do the command twice I received an error (because of the vlan is always there) => I expected the value != "0" for STATUS

    My question is my expectation is wrong? Or what do I wrong?

    Best regards


  • 2.  RE: XMC - System Variables

    Posted 03-13-2018 20:14
    Hello all,

    according GTAC the $STATUS variable isn't supported with python.
    The documentation will be revised in future.

    Thank you to GTAC for clarification.

    Best regards