ExtremeCloud IQ- Site Engine & Extreme Management Center

  • 1.  Different NAC Portal Page

    Posted 10-20-2015 10:30
    Hi community

    I would like to configure different NAC portal pages for different locations.
    I have created additional portal pages.
    I have created a rule that forces the use of the new Portal page when I authenticate from a specific location but this seem intermittent.
    Some users get the default portal page and other get the Custom Portal Page

    What is the correct setup for this Solution?
    I have attached a copy of my rules.



  • 2.  RE: Different NAC Portal Page

    Posted 10-20-2015 16:58
    Check which rule is hit = which role/portal the client get's.

    If the client hit the "Client-Andre" rule he should get the custom portal - if rule "unregistered" is hit then the default portal is used.

    If the problem is related that "Client-Andre" rule isn't used right-click the client in the NAC end-system tab and click > configuration evaluation tool > run evaluation ...and look why the rule isn't used.

    BTW, how is your location group configured - are you using AP zone or what is your option to get the location right?

    -Ron


  • 3.  RE: Different NAC Portal Page

    Posted 10-20-2015 16:58
    ...and make sure that the NAC configuration is enforced 🙂


  • 4.  RE: Different NAC Portal Page



  • 5.  RE: Different NAC Portal Page



  • 6.  RE: Different NAC Portal Page

    Posted 10-21-2015 13:20
    Thx Ronald

    I think I have found my problem.
    Currently the V2110 and NAC is deployed in the cloud.
    I have the VNS setup to return the SSID via radius attributes to the NAC.

    What seems to be happening is that when a client connects the "Switch Port" in nac first displays the "Topology name" and only 10 seconds later updates this with the SSID.

    So when I connect and wait a few seconds and then open a browser I receive the correct Page.
    If I browse within the 10 seconds the default NAC rule applies because the location does not match.
    I am going to add the topology name in the location list.

    Thx
    Andre