ExtremeCloud IQ- Site Engine & Extreme Management Center

Expand all | Collapse all

EMC Flexreport Device bandwitdh: shows only some kilobytes

  • 1.  EMC Flexreport Device bandwitdh: shows only some kilobytes

    Posted 08-30-2017 05:28
    Hi,
    when I look at EMC 8.0.3 / Network / Devices / at one of our S-Series Switches, the flexreport for Device bandwidth shows a graph moving between 20 and 80 kbs. What is the source of this data? (The S-Series actually moves much more data around.)

    It seems to have something to to with report "Top Devicess by IP Traffic". There are also shown quite small numbers.


  • 2.  RE: EMC Flexreport Device bandwitdh: shows only some kilobytes

    Posted 08-30-2017 05:55
    Hi,

    is this a default report ?customized one?

    Thanks,
    Suresh.B



  • 3.  RE: EMC Flexreport Device bandwitdh: shows only some kilobytes

    Posted 08-30-2017 06:12
    Hi, it's a default report.


  • 4.  RE: EMC Flexreport Device bandwitdh: shows only some kilobytes

    Posted 08-30-2017 08:06
    Hi,

    The calculation of the report should be displayed below once you select it.
    Device IPv4 Bandwidth (kbps). Source (SNMPv1): ipSystemStatsInOctets + ipSystemStatsOutOctets Source (SNMPv2c/v3): ipSystemStatsHCInOctets + ipSystemStatsHCOutOctets



  • 5.  RE: EMC Flexreport Device bandwitdh: shows only some kilobytes

    Posted 08-30-2017 08:49
    Hi,
    I found the definition of ipSystemInOctets:
      The total number of octets received in input IP datagrams, including those received in error. Octets from datagrams counted in ipSystemStatsInReceives MUST be counted here.[/code]
    Are all switch/router-octets counted system-wide or only those going in and out the Management IP-Interface? (our S,K and 7100 Series deliver quite low values in the kbs range, our new test summits deliver none)