ExtremeCloud IQ- Site Engine & Extreme Management Center

Expand all | Collapse all

Question about EMC/NetSight -Device Details -Trap Receiver Registration

  • 1.  Question about EMC/NetSight -Device Details -Trap Receiver Registration

    Posted 05-25-2018 07:45
    Hello,
    I'm using EMC/NetSight in Version 8.1.2.59 and OneView via HTML.

    If I check the status of the trap receiver registration before and after a reboot of a switch, the status will change from "Trap Receiver Registrated" to "Trap Receiver Unregistrated".

    But I have no idea why this is happen.

    I can reproduce this effect with different switches (C3, C5, G-Serie) and if I compare the configuration before and after the reboot of the switch there is nothing different.



    I can right-click the switch to register the trap receiver again but then an additional config line will be added to the switch config like

    set snmp targetaddr TVnetsight ... <-- this is the orginal entry
    set snmp targetaddr TVnetsight" ... <-- this is the new entry

    Does anybody has seen this, too?
    Any ideas are welcome.

    Thanks,
    Axel



  • 2.  RE: Question about EMC/NetSight -Device Details -Trap Receiver Registration

    Posted 05-25-2018 09:26
    I don't see that on my XMC, I run the same version and use a B5 instead of the C5.

    Try a refresh/rediscover of the switch in XMC and then reboot the switch again to see whether that solved the issue.

    XMC GUI > right-click switch > device > refresh (rediscover) device


  • 3.  RE: Question about EMC/NetSight -Device Details -Trap Receiver Registration

    Posted 05-28-2018 02:56
    Hi Ronald,
    I've tried to refresh/rediscover the switch, the group and all but it dosn't fix the problem.
    Thanks for trying to help,
    Axel