ExtremeCloud IQ- Site Engine & Extreme Management Center

Expand all | Collapse all

NAC end-system MAC Mask

  • 1.  NAC end-system MAC Mask

    Posted 08-02-2017 15:17
    Hi,

    Currently running version 8.0.2.42, and am in the process of writing a MAC Mask in NAC / Control.

    What I'm not sure is if I have entered it correctly, and can't seem to find any working examples.

    Here is what I have entered:



    Problem with this is when I hit update it will just permanently sit there 'Loading' until I cancel it:



    I can go back into it again but the MAC address part is missing, so perhaps I'm doing something wrong?



    If anyone has example might be good?

    Many thanks.



  • 2.  RE: NAC end-system MAC Mask

    Posted 08-02-2017 16:20
    Wasn't too far off in the end, the answer is:





  • 3.  RE: NAC end-system MAC Mask

    Posted 08-02-2017 16:35
    Wouldn't work for my APs as you'd see on my AP MAC list - I've some older models and even the Extreme APs are not from the same production patch.

    Might be better to use only the vendor OUI = D4:84:66:00:00:00 FF:FF:FF:00:00:00 instead of also using the 4th byte.

    -Ron





  • 4.  RE: NAC end-system MAC Mask

    Posted 08-03-2017 06:34
    Hi Martin,

    I would have expected that all six bytes of the MAC need to be specified, similar to IPv4 networks, as you found out.

    It would be nice for EMC / EAC to issue an error message if the input is obviously incorrect (e.g. missing bytes).

    Thanks,
    Erik


  • 5.  RE: NAC end-system MAC Mask

    Posted 08-02-2017 16:35
    Thanks Ron.


  • 6.  RE: NAC end-system MAC Mask

    Posted 08-03-2017 06:34
    Thanks Erik