Conversations

Photo of Nico Lueck
Fujitsu Server with Intel X722 NIC compatibility with 5m DAC (10G)
Customer try to connect the Server to a X620 with 5m DA Cable. But there is no link. Do anyone of you have an Idea about the compatibili...
  • 1 me too
  • 4 replies
  • Question
  • Answered
Photo of Nico Lueck
Summit Stack - Daisy chain to ring topologie
Hi community, I just added 2 switches to a existing stack (2 switches). Now my question, when changing the topologie from daisy chain to...
  • 2 me toos
  • 2 replies
  • Question
  • Answered
Photo of Nico Lueck
Best Practice: Replacing Core Stack Master incl. MLAG Master
Hi, customer having Following Setup: Now I need to replace the both Stack master regarding: https://gtacknowledge.extremenetwork...
  • 1 me too
  • 3 replies
  • Idea
Photo of Nico Lueck
I need the Summit-G2 Visio Stencil in VSS format
Is there any way to get the G2 especially 440-G2 in VSS instead of VSSX, as I only have Visio 2010.
  • 2 me toos
  • 7 replies
  • Question
  • Answered
Photo of Nico Lueck
Visio Stencil for Summit X690?
are there already Visio Stencils for the X690-48x-2q-4c
  • 3 me toos
  • 4 replies
  • Question
  • Answered
Photo of Nico Lueck
netscaler/citrix server send gratuitous arp which is not recordnised by S8 Core Switch
Our Customer is using a netscaler. Server (main&backup) is using same IP Address. When there is an failover on server site, the server s...
  • 1 me too
  • 4 replies
  • Problem
  • Solved
Photo of Rien Maurik
Config Example LAG between C3 stack and summit X450-g2 MLAG
Hello All Does anyone have a good and stable config example for me to set up a lag of 4Gb (4x1Gb) between a C3 stack of 4 units and a MLa...
  • 1 me too
  • 11 replies
  • Problem
  • Solved
Photo of Nico Lueck
FW 22.1.1.5 unable to unconfigure Tacacs
I have a customer using FW Version 21.1.1.4 We did an update to 22.1.1.5 Since then under configuration aaa there is tacacs configurati...
  • 1 me too
  • 3 replies
  • Problem
  • Solved
Photo of Nico Lueck
not able to configure sharing when using GNS3
I Start using GNS3 (Version 22.1.1.5) and trying to set up a link aggregation. When using the standard sharing command I'm getting the f...
  • 1 me too
  • 7 replies
  • Problem
  • Solved
Photo of Nico Lueck
Is it possible to do a firmware update on a Summit using xmodem/serial port
Can't find any description about it..
  • 1 me too
  • 5 replies
  • Question
  • Answered