Conversations

Photo of Stephen Stormont
Two offices setup with the same configs, but different hardware and XOS versions, but WOL won't work on the newer equipment
We have one site with the following configs:Location ACore switch (Summit x450a running XOS 15.3.4.6) that is connected to a desktop stac...
  • 1 me too
  • 2 replies
  • Question
Photo of Stephen Stormont
Log into switch with LDAP credentials
Currently, we are using accounts created on each switch in order to be able to login. We do have Extreme Management Center 8.x installed...
  • 2 me toos
  • 15 replies
  • Question
  • Answered
Photo of Stephen Stormont
"Error: Error validating certificate" when trying to install signed certificate for SSL
We ran this command "config ssl csr privkeylen 2048 country US organization IMS common-name Summit-RV-Core" and then took the output, sig...
  • 1 me too
  • 1 reply
  • Question
  • Answered
Photo of Stephen Stormont
Is this QOS configuration really doing what we want it to?
Our VoIP phones send traffic with a DSCP value of 46.  The phones are connected to a Summit X440-G2 stack in a VLAN called "VoIP" that ha...
  • 3 me toos
  • 4 replies
  • Question
Photo of Stephen Stormont
Enable SNMPv3 with enhanced security
We are setting up some x460G2 and x440G2 units and we chose the initial option to use "enhanced security" which disables SNMP.    We only...
  • 2 me toos
  • 3 replies
  • Question
  • Answered
Photo of Stephen Stormont
ZTP+: Invalid configuration provided by controller IP address extremecontrol
I have a X460G2-24t-10G4 that has connected to Extreme Management via ZTP+.  It is in a "ZTP+ Pending Edit" stage, but when I edit it and...
  • 1 me too
  • 8 replies
  • Question
  • Answered
Photo of Stephen Stormont
Trying to setup IDM and failing
We have Extreme Management Console and ExtremeControl and we want to start off by just collecting information on what all is connected to...
  • 1 me too
  • 9 replies
  • Question
  • Answered
Photo of Stephen Stormont
UPM script to send syslog keepalive messages every hour
We currently have our switches set up to send syslog messages to a centralized server which will send an alert out if a device hasn't sen...
  • 1 me too
  • 2 replies
  • Question
  • Answered
Photo of Stephen Stormont
Script synax that waits on user input before committing changes?
We want to create a script that will do the following: show port 5:2,6:1 info Wait for user to answer if the ports shown are the correct...
  • 1 me too
  • 5 replies
  • Question
  • Answered
Photo of Stephen Stormont
Illegal password characters in XOS?
Are there illegal password characters in XOS?  As an example, I had been trying to change a password on a Summit running 15.2.1.5 to ...
  • 1 me too
  • 5 replies
  • Question
  • Answered
Photo of Stephen Stormont
Two sites, two switches, and issue setting up RIP
We have two sites with two Summit switches at each.  We had a MPLS connection between the two sites and have since added a direct point t...
  • 1 me too
  • 12 replies
  • Question
Photo of Stephen Stormont
PacketFence and Summit switches
                Sorry for the amount of detail, but we are trying to setup PacketFence with our Summit switches and I think everything l...
  • 1 me too
  • 7 replies
  • Question