[AP3610] ERROR: Cannot boot either kernel image, dropping to interactive shell.

  • 0
  • 1
  • Question
  • Updated 2 years ago
  • Answered
Hello,

I need for recovery a AP3610 with kernel error. Does anyone know how I can fix this error? Some steps for getting the firmware image on the access point would be nice to have

Regards
Chris


U-Boot 1.2.0.07-dirty (Sep 23 2015 - 14:24:57)

Primary Image

DRAM:  128 MB
Flash: 16 MB
In:    serial
Out:   serial
Err:   serial
Net:   eth0
Hit any key to stop autoboot:  0
### JFFS2 loading 'boot_kernel.img2' to 0x80400000
Scanning JFFS2 FS: . done.
### JFFS2 load complete: 2979 bytes loaded to 0x80400000

## Checking Image at 80400000 ...
   Image Name:   Boot ROM Script
   Created:      2010-06-21  17:46:19 UTC
   Image Type:   PowerPC Linux Script (uncompressed)
   Data Size:    2915 Bytes =  2.8 kB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
## Executing script at 80400000
check for watchdog, limit=3...
check for reset by watchdog...
no watchdog...
bSaveEnviron=0 image_order=primary secondary
### JFFS2 loading 'primary.gz.uImage' to 0x80500000
### JFFS2 load complete: 5352637 bytes loaded to 0x80500000
ready to boot kernel, starting watchdog...
## Booting image at 80500000 ...
   Image Name:   Linux Kernel Image (LZMA)
   Created:      2015-12-02  17:31:56 UTC
   Image Type:   MIPS Linux Kernel Image (uncompressed)
   Data Size:    5352573 Bytes =  5.1 MB
   Load Address: 84000000
   Entry Point:  8400239c
   Verifying Checksum ... Bad Data CRC
boot failed - stopped watchdog
### JFFS2 loading 'secondary.gz.uImage' to 0x80500000
### JFFS2 load complete: 5352801 bytes loaded to 0x80500000
ready to boot kernel, starting watchdog...
## Booting image at 80500000 ...
   Image Name:   Linux Kernel Image (LZMA)
   Created:      2015-09-23  18:24:46 UTC
   Image Type:   MIPS Linux Kernel Image (uncompressed)
   Data Size:    5352737 Bytes =  5.1 MB
   Load Address: 84000000
   Entry Point:  8400239c
   Verifying Checksum ... Bad Data CRC
boot failed - stopped watchdog
ERROR: Cannot boot either kernel image, dropping to interactive shell.
Photo of n.n. n.n.

n.n. n.n.

  • 514 Points 500 badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of Doug Hyde

Doug Hyde, Technical Support Manager

  • 20,502 Points 20k badge 2x thumb
You should contact GTAC for assistance, the unit will need to be replaced or repaired based on your contract agreement (if any) with Extreme. 

https://gtacknowledge.extremenetworks.com/articles/How_To/Return-Material-Authorization-RMA-Process-...