10 gig port of extreme X460G2-24x-10G4. It is showing low Rx power

  • 0
  • 1
  • Problem
  • Updated 2 months ago
  • Not a Problem
  • (Edited)
HI experts ,I have connected one server on 10 gig port of exterme X460G2-24x-10G4. It is showing low Rx power and port is not coming up. Please help 


POC_SW01.23 # show ports 31 transceiver information

Port      Temp    TxPower  RxPower  TxBiasCurrent  Voltage-Aux1/ Voltage-Aux2
       (Celsius)   (dBm)    (dBm)     (mA)         Vcc (Volts)       (Volts)
================================================================================
31        31.06    -2.76    -26.78*    8.63          3.34          N/A
================================================================================
      N/A - parameter not applicable to transceiver connected to the port
      *   - value is out of normal range
 

 # debug hal show optic port 31
Port                       31
SFP or SFP+:               SFP+
Signal:                    not present
TX Fault:                  no
SFP/SFP+ Vendor:           FINISAR CORP.
SFP/SFP+ Part Number:      FTLX8574D3BCL-EX
SFP/SFP+ Serial Number:    1639P-05940
SFP/SFP+ Manufacture Date: 160924
SFP/SFP+ Type:             SFP/SFP+
Connector:                 LC
Type:                      SR
Wavelength:                850
Photo of priti

priti

  • 70 Points

Posted 2 months ago

  • 0
  • 1
Photo of David Rahn

David Rahn

  • 1,036 Points 1k badge 2x thumb
why kind of fiber are you connecting it with? have you tried a different jumper?
if the RX is low the issue is that the light is not getting to the receiver. can you see the light coming out of the server SFP? ( I know you are not supposed to look etc... so do so at your own risk, 850 nm LED is not tooo dangerious)


Photo of Erik Auerswald

Erik Auerswald, Embassador

  • 13,772 Points 10k badge 2x thumb
You can use a camera, e.g. from a phone, to avoid looking directly at the laser.
Photo of Grosjean, Stephane

Grosjean, Stephane, Employee

  • 13,608 Points 10k badge 2x thumb
Please, do NOT look directly at the fiber.

If Rx is too low, it's expected the port do not come up. The issue is either on the fiber plant, jumper, length, dust anywhere there's connection or the transmitter has an issue. Eventually a mix of all of it.
Photo of Eric Burke

Eric Burke

  • 3,288 Points 3k badge 2x thumb
It’s possible you simply need to swap fibers on one end of the patch. This is a common problem. As others said, red led is transmit and should go to dark connector on the opposing device.