cancel
Showing results for 
Search instead for 
Did you mean: 

Active IP VLANS & Routing Oh My...

Active IP VLANS & Routing Oh My...

Brian2
New Contributor
I have a question in regards to the VR-Default and active IP4 VLANS. I created two new VLAN's according to the documentation and assigned them IP's but they show up as inactive. What am I missing. I would just like to route traffic between the VLAN's. Sorry I am new to the ExtremeOS world. Here is the show for the VR and one of the new VLAN's I created as well as the show iproute. The two new VLAN's are Wireless and Desktop.

I am new to ExtremeOS and am trying to wrap my head around it.

Thanks in advance.

Virtual Router : VR-Default Type : System
Description : Default VR
Operational State : Up
IPv4 Admin State : Enabled IPv6 Admin State : Enabled
IPv4 Route Sharing : Disabled IPv6 Route Sharing : Disabled
Protocols Configured :
--------------------------------------------------------------------
Protocol Process Configuration Protocol
Name Name Module Name Instances
--------------------------------------------------------------------
RIP rip rip 1
R.png r.png r.png 1
--------------------------------------------------------------------
Port List : 1-50
VLANS : Default, VoiceVLAN, Data,
Wireless, Desktop
Virtual Router Totals :
Total Protocols : 2 Max Protocols : 8
Total Ports : 50
Total Vlans : 5
Total IPv4 Vlans : 4 Total Ipv6 Vlans : 0
Active IPv4 Vlans : 2 Active Ipv6 Vlans : 0
Inactive IPv4 Vlans : 2 Inactive Ipv6 Vlans : 0

sh iproute
Ori Destination Gateway Mtr Flags VLAN Duration
#d 192.168.10.0/24 192.168.10.253 1 U------um--f- Data 691d:4h:59m:20s
#d 192.168.20.0/24 192.168.20.253 1 U------um--f- VoiceVLAN 1138d:4h:39m:59s
d 192.168.30.0/24 192.168.30.254 1 -------um---- Wireless 1d:1h:5m:5s
d 192.168.40.0/24 192.168.40.254 1 -------um---- Desktop 1d:1h:4m:30s

4 REPLIES 4

Stephane_Grosj1
Extreme Employee
Hi, yes the purpose of a loopback interface is to keep your vlan interface always Up. It can be a good thing, but can also turn out to be a bad idea, depending on the topology and use case. If your router is keeping advertising the route to a resource it can't reach anymore, that's not necessarily a good idea.

As correctly stated previously, for your vlan interface to be Up, you need at least one active port in it, and enable ipforwarding for that vlan as well. Then routing can happen with other vlans with ipforwarding also enabled. This is also a prerequisite to configure any dynamic routing protocol, like OSPF.

Brian2
New Contributor
Thanks all. I also figured out if i enabled the loopback it shows up and actually responds to a ping 

CEFLOU
New Contributor II
Hi brian, y Just activate ipforwading and put each port in the right vlan. If y dont connect any think on port based vlan y never have the vlan interface up  i'm new in extreme too

Sumit_Tokle
Contributor
Make sure that you have added the port in VLANs and at least one of the port should be in active state to activate the vlan.

You also need to enable ipforwarding on communicate between two vlans.
GTM-P2G8KFN