cancel
Showing results for 
Search instead for 
Did you mean: 

Add vlan to existing switch and ospf routing

Add vlan to existing switch and ospf routing

Sidney_Yoder
New Contributor
Not able to ping new vlan default gateway

Name VID Protocol Addr Flags Proto Ports Virtual Active router /Total

---------------------------------------------------------------------------------------

corp_CTAP_agents 3710 10.131.82.1 /24 -f----------------------- ANY 0 /1 VR-Default

CTAP-Agent 500 192.168.112.1 /24 -f----------------------- ANY 80/132 VR-Default

Default 1 --------------------------------------------- ANY 0 /0 VR-Default

EVN 501 10.20.50.1 /24 -f----------------------- ANY 1 /3 VR-Default

IPC 502 172.16.50.1 /24 -f----------------------- ANY 1 /4 VR-Default

IVN 503 192.168.50.1 /24 -f----------------------- ANY 1 /7 VR-Default

Mgmt 4095 --------------------------------------------- ANY 0 /1 VR-Mgmt

XO_VPLS_MESH 1000 10.128.254.4 /24 -f-------o--------------- ANY 1 /1 VR-Default



VLAN Interface with name corp_CTAP_agents created by user

Admin State: Enabled Tagging: 802.1Q Tag 3710

Description: None

Virtual router: VR-Default

IPv4 Forwarding: Enabled

Primary IP : 10.131.82.1/24

IPv6 Forwarding: Disabled

IPv6: None

STPD: None

Protocol: Match all unfiltered protocols

Loopback: Disabled

NetLogin: Disabled

QosProfile: None configured

Egress Rate Limit Designated Port: None configured

Flood Rate Limit QosProfile: None configured

Ports: 1. (Number of active ports=0)

Untag: 3:44

20 REPLIES 20

Bill_Stritzinge
Extreme Employee
First you need to establish that you can ping the switch from the laptop and vice versa, then we can try to figure out from there. You may want to call GTAC and open a case that way we can walk through it and do some direct follow-up?

Sidney_Yoder
New Contributor
another odd item is when i do a show iparp, i'm not seeing the vlan, I have a laptop plugged in now.

Bill_Stritzinge
Extreme Employee
I assume that the PC can ping the switch now?? 10.131.82.1 ? From the switch can you ping the PC? Then run the command "show iproute origin direct" - you should see something like this...

#d 10.131.82.0/24 etc....

Make sure fowarding is still enabled... "enable ipforwarding vlan corp_CTAP_agents"

You can also do a "show iparp vlan corp_CTAP_agents" and see the IP's of the interface as well as the PC...

Sidney_Yoder
New Contributor
I had our center mgr, move the cable from sw3 to sw2 and you can see it's active, still can not ping it.

4d908e5b4f1d4f96be428bb49d31b6f5_RackMultipart20150313-17757-1mu5kew-1_inline.png



i'm running this code:
: ExtremeXOS version 12.6.5.2 v1265b2-patch1-3 by release-manager on Thu Feb 20 19:12:11 EST 2014
BootROM : 1.0.3.5
Diagnostics : 3.4

i wish we could upgrade but we can not.
GTM-P2G8KFN