AP 7161

  • 0
  • 1
  • Question
  • Updated 1 year ago
  • Answered
Hi All...
I have a question about Motorola Access Point 7161.
How to connect two device AP 7161 with 5GHz Frequency use WiNG 5.5 GUI ?
Photo of Wicaksono Arief R

Wicaksono Arief R

  • 70 Points
  • confused

Posted 2 years ago

  • 0
  • 1
Photo of Ondrej Lepa

Ondrej Lepa, Employee

  • 5,638 Points 5k badge 2x thumb
Hi Wicaksono,

could you be a little more specific? 
You are looking for a way to create wireless bridge between two APs, right?
For this we recommend to use MeshConnex policy (MCX) and map it as BSS1 on 5GHz enabled radio.

However I have WiNG 5.8 running the process is almost the same.
Go to Configuration - Wireless - MeshConnex Policy



Then under Configuration - Devices / Profile - Interfaces - Radio2 - WLAN / MESH mapping assign the MCX you created



If you need more details please refer to WiNG 5.5 Reference Guide or take a look into MeshConnex Overview document available under following link

Edit: Here is document for Virtual Controller environment

Regards,
Ondrej
(Edited)
Photo of Ondrej Lepa

Ondrej Lepa, Employee

  • 5,638 Points 5k badge 2x thumb
Wicaksono,

I forgot one important thing - you need to map the MeshConnex policy to a device / profile.



Please let me know if you have any issues with your deployment.

Regards,
Ondrej
Photo of Tuan Nguyen

Tuan Nguyen

  • 112 Points 100 badge 2x thumb
Hello friends

Where can I download firmware win 5.7 for Ap 7161
Photo of Tuan Nguyen

Tuan Nguyen

  • 112 Points 100 badge 2x thumb
Hello Ondrej Lepa

I have updated successfully fw 5.8.6.5 for Ap7161, I have configured mcx as guide but not successful, can you help me through skype or teamview?

Thank you very much
Photo of Ondrej Lepa

Ondrej Lepa, Employee

  • 5,554 Points 5k badge 2x thumb
Tuan, 

please open support case via Extreme Portal or by sending email to our inbox and we will check.

Thank you,
Ondrej
Photo of Tuan Nguyen

Tuan Nguyen

  • 112 Points 100 badge 2x thumb
Thanks Ondrej Lepa

Please check your email, hope your support
(Edited)
Photo of Tuan Nguyen

Tuan Nguyen

  • 112 Points 100 badge 2x thumb
Dear Ondrej Lepa

I can't send email direct to support@extremenetworks.com, i create case but failed. It looks like my device is no longer supported.

Photo of Steven Lin

Steven Lin, Employee

  • 2,320 Points 2k badge 2x thumb
Hello Tuan,
This error 404 because of you email haven't associated with an account or don't have an valid Service contract. But you could still open a case through email(still need to check the service contract for the tech support). Please view the GTAC user guide from below link for more detail about how to open case by email.
https://gtacknowledge.extremenetworks.com/articles/Q_A/Where-is-the-GTAC-User-Guide