cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

AP7522 - Radio1 Keeps getting turned off - "RADIO STATE HIDDEN"

AP7522 - Radio1 Keeps getting turned off - "RADIO STATE HIDDEN"

steve_kemball
New Contributor III

AP7522 Wing5.9.2.0-032R in VC mode. Various APs turning off 2.4GHz radio
11 REPLIES 11

Andrew_Blomley
Extreme Employee
Smart RF is switching of the 2.4Ghz radio because it belive there is to much RF in the 2.4Ghz band

following lines configure this feature

select-shutdown
select-shutdown cci-high-threshold -80
select-shutdown cci-low-threshold -100
select-shutdown frequency-limiter 10
select-shutdown frequency 60

to disable

no select-shutdown

I would state this is a very good feature,and i would not recommend disabling it


Thank you. I can't install a tftp server on the remote P.C so the best I could do was run the various smart-rf outputs via CLI into notepad including interfering APs, neighbours, history etc.

download from here:
https://drive.google.com/file/d/1RvHX5vC-mtaWzLAXW4esfF2geZyL_2X6/view?usp=sharing

please up load the smart rf report, so we can see why the aps are choosing channel 6 there must be a good reason

#remote-debug copy-smart-rf-report rf-domain default write

URL URLs: tftp://[:port]/path/
ftp://:@[:port]/path/
IPv6 URLs: tftp://[:port]/path/
ftp://:@[:port]/path/




Thank you. I have applied this to the smart rf policy via CLI. If I don't disable it the site loses coverage - there are some BT hubs located in the vicinity of 2 APs in the warehouse so this may be the cause of the problem. Of note all 4 APs are using ch 6 so this could indicate congestion.
GTM-P2G8KFN