Applying IPv6 Router licensing to the SecureStack C3

  • 0
  • 1
  • Article
  • Updated 4 years ago
  • (Edited)
Article ID: 5873 

SecureStack C3
Firmware 1.00.80 and higher


'set license'
'license advanced' 

IPv6 Router licensing 

"No match for serial number" 

On the SecureStack C3 routing products, the use of the IPv6 routing feature requires the purchase and installation of an IPv6 Router License. 

Part# C3IPV6-LIC is compatible with SecureStack C3 firmware 1.00.80 and higher, is node-locked, and must be applied individually for each standalone or stacked unit using switching command 'set license INCREMENT...': 
 C3(rw)->set license INCREMENT ipv6router 2007.0928 permanent 11C4010316EC 06502013905A 
Validating license on unit 1
License successfully validated and set on unit 1
C3(rw)->show license
unit 1
key: INCREMENT ipv6router 2007.0928 permanent 11C4010316EC 06502013905A
status: Active

This command must use an upper-case serial#. The command will not be accepted unless the typed serial number matches to both the serial number encrypted into the license key during Activation, and to the actual serial number of a switch within the managed stack; or error message "No match for serial number" will be issued. 

SecureStack C3 firmware would be expected to be used for a C3 standalone unit, or all units of a C3 stack. 

Note1: In order to obtain the license key to be configured as described above, it is first necessary to redeem your purchased license entitlement in "Enterasys Licensing" (10833). 
Note2: If a license is applied to any units in the stack, it must be applied to all units in the stack. Otherwise, some units will not join the stack because of a mismatched feature. 

See also: 5834

FAD (Functions as Designed).
Photo of FAQ User

FAQ User, Official Rep

  • 13,590 Points 10k badge 2x thumb

Posted 4 years ago

  • 0
  • 1

There are no replies.

This conversation is no longer open for comments or replies.