'arptnew' Error Message in SecureStack/Matrix CLI/Syslog

  • 0
  • 1
  • Article
  • Updated 4 years ago
  • (Edited)
Article ID: 5350 

Matrix C1
Matrix C2
SecureStack C2
SecureStack B2

Error message
Syslog message
"Default[1.tNetTask]arptnew failed"

A full example of such an error message, potentially seen directly in the cli or in the output of a syslog, is shown here:
<165>Mar 17 08:02:50 Default[1.tNetTask]arptnew failed on a18e725 is alive

This message is produced by code in the third-party HOST IP stack. It indicates that the stack was creating an ARP entry when it discovered that creation of the entry would be inappropriate. Based on the host subnet mask and route configuration, the IP address in the entry being created should be associated with a gateway, external to the switch.

The host probably received an ARP directly from the IP Address in question due to incorrect configuration of the mask, gateway, or routes on the network in general - possibly on the device issuing the error message. Misconfiguration of the host port vlan egress is also suspect.

Investigate and correct the network misconfiguration.

The hex number in the error message represents the IP address of the entry being processed. For example, "a18e725" should convert as 10 (0x0a), 24 (0x18), 231 (0xe7), 37 (0x25); or IP Address
Photo of FAQ User

FAQ User, Official Rep

  • 13,590 Points 10k badge 2x thumb

Posted 4 years ago

  • 0
  • 1

There are no replies.

This conversation is no longer open for comments or replies.