I have a full spb environment and an IDE to authenticate the clients via MAC.
In addition, I would like to send a vlan/i-sid that exist in the spb but not on the switch to the port.
Is it possible?I have this working with FA but I cannot find how to do it in a SPB switch.
Not following you when you say "I have this working with FA but I cannot find how to do it in a SPB switch."...do you not have an FA Proxy switch and FA Server switch set up? if you do, then the FA Proxy switch will communicate the required VLAN:ISID mapping upstream to the FA Server switch. Or perhaps you have SPB to the edge? which switches are involved here.
Just as a reminder to all readers, ExtremeControl also fully supports FA.
If I understand you correctly, you would like IDE to send the VLAN/I-SID to the switch after a MAC authenticated device attaches.
If this is correct then you will need to create a new Outbound Attribute and Outbound Values.
Please go to https://downloads.avaya.com/css/P8/documents/101008758
Beginning on page 33 you will see the instructions.
I am currently using ERS 4800 and VSP 4000.
I have the solution working in the switchs that are connected via FA (FA proxy) like in the manual.
My problem is in the FA server. All the examples that I see are for FA proxy.The VSP 4000 are part of the SPB cloud. I want to send the VLAN/I-Sid to the port like I send to the FA Proxy. That means that if needed I can send a VLAN/I-Sid that is not configured in the switch (like I can do in the FA Proxy).